Re: [ARSCLIST] Instant Recording Discs, was Re: [ARSCLIST] Record Gunk

[David Lennick <dlennick@xxxxxxxxxxxx>]

I always said Steve had a loose screw..

dl

Steven Smolian wrote:

> The solution I use is to drill a hole in a turntable mat aligned with the
> second hole, stick a thin screw in it up side down, put the mat back on the
> turntable, and put the record on the spindle, aligning the second hole with
> the protruding screw.
>
> Steve Smolian
>
> ----- Original Message -----
> From: <Mwcpc6@xxxxxxx>
> To: <ARSCLIST@xxxxxxxxxxxx>
> Sent: Thursday, October 12, 2006 10:24 AM
> Subject: Re: [ARSCLIST] Instant Recording Discs, was Re: [ARSCLIST] Record
> Gunk
>
> > In a message dated 10/12/2006 10:13:59 AM Eastern Daylight Time,
> > fbsdmd@xxxxxxxxx writes:
> >> Other than to say drill the hole bigger, which I'm sure is the wrong
> > answer, I can't help with the playing of these disks.  I can say, however,
> > that the pin in the middle of the platter has usually been called a
> > "spindle."
> > **************
> >
> > Usually the tip of the spindle is tapered or rounded. A solution sometimes
> > suggested if the spindle is not removable, also useful for centering, is
> > to
> > place other records on the turntable first to raise the disc above the
> > start of
> > the taper.
> >
> > Mike Csontos
> >
> >
> > --
> > No virus found in this incoming message.
> > Checked by AVG Free Edition.
> > Version: 7.1.408 / Virus Database: 268.13.2/472 - Release Date: 10/11/2006
> >
> >